SWP

2 product code

SWP

SWP is a sealing component for controlling lubricant leakage and limiting contamination at the mounting position. Confirm size, material and operating conditions before selection.

Loading product code list…

Detailed technical content

A rotary shaft seal seals in two different areas at the same time

In a typical rotary shaft seal, the outside diameter forms a static seal with the housing bore, while the sealing lip forms a dynamic seal on the shaft surface. SKF describes a radial shaft seal as having an outer casing that provides an interference fit in the bearing housing and a sealing lip that contacts the shaft; many designs also have a garter spring to maintain lip load and an auxiliary lip to exclude dust.

Therefore, when replacing a seal, the three dimensions shaft diameter d, housing bore diameter D and width B are only the starting point. Also check the profile, number of lips, presence or absence of a spring, outside-diameter design, lip material and sealing direction.

Different profiles serve different sealing requirements

The current catalog includes many profiles such as EC, HDS1, HDS2, HMS, MHS, MS, SA, SB, SC, TA, TB, TC, TCN and TG4. Do not assume that these codes have one consistent meaning across all manufacturers. DEDE shows that even within its standard seal group, TA and TB differ in casing/frame construction although both have a primary lip, auxiliary lip and spring.

When seeking an equivalent designation across brands, therefore compare the profile cross-section drawing and profile function, not only the three basic dimensions or suffix name.

The shaft surface and operating conditions determine service life

The contact area between the lip and shaft is the most important functional area. A shaft surface with a wear groove, scratch, corrosion or burr can cause a new seal to leak immediately after replacement. SKF also notes that temperature, speed, medium, pressure differential, eccentricity and contamination all affect sealing performance.

In applications with heavy dust or contaminants, a profile with an auxiliary lip can provide additional exclusion. However, adding another contact lip also increases friction and heat, so more lips are not always better in every situation.

The material must suit the medium and temperature

NBR, FKM and other materials have different operating ranges and compatibility. If an old seal failed because of heat or chemicals, replacing it with a seal of the same size and the same old material may repeat the failure. Any change of material must be based on the manufacturer’s specifications and actual operating conditions.

FAQ

Frequently asked questions

Can two oil seals with the same d × D × B dimensions be directly interchanged?

No. They may differ in profile, number of lips, spring, material and outside-diameter construction. These differences affect oil retention, contamination exclusion, friction and installation. Compare the full designation, profile or cross-sectional drawing instead of selecting a seal only because it fits the dimensions.

Can a profile from another manufacturer be used when its designation appears similar?

Do not infer compatibility from the name. Profile codes are not always standardized between manufacturers. A similarly named profile may still differ in auxiliary lip, metal case or outside construction. Safely compare the cross-sectional drawings, dimensions, sealing function and materials of both products.

Why can oil still leak from the same position after fitting a new seal?

A common cause is a wear groove on the shaft where the old seal lip operated. If the new lip runs on the same groove, sealing can remain poor. Also check the housing bore, shaft runout, burrs, installation direction, initial lubrication and concentricity before concluding that the new seal is defective.

Is a seal with an additional dust lip always better than a single-lip seal?

No. An auxiliary lip is useful for limiting dust or contaminants reaching the main lip, but another contacting lip can also increase friction and heat. Select one or two lips according to contamination, speed and machine design rather than choosing the greatest number of lips.

Can NBR be changed to FKM solely to increase temperature resistance?

It may be suitable in some applications, but temperature alone is not enough. Check fluid compatibility, speed, hardness, lubrication conditions and seal profile. The manufacturer must confirm that the new material suits the complete operating conditions, not only one temperature value.

News about Industrial seals