Tapered roller bearing

322 product code

Tapered roller bearing

Tapered roller bearing is a bearing family for rotating machinery. Select the design according to load, speed, alignment and mounting requirements.

Loading product code list…

Detailed technical content

Contact angle and load capacity

In a tapered roller bearing, the generatrices of the raceways and rollers are arranged to meet near a common point on the bearing axis. This geometry allows a radial load to create an axial-load component and makes the contact angle an important selection parameter. In general, a larger contact angle allows the bearing to carry a higher axial-load component.

Separable design and paired arrangements

Single-row tapered roller bearings usually have a separable design: the inner-ring, roller and cage assembly can be mounted separately from the outer ring. This is convenient for installation and maintenance, but it also means that adjusting the relative position of two bearings in an assembly affects clearance or preload.

A single-row tapered roller bearing primarily carries axial load in one direction. Therefore, two bearings are often arranged opposite each other in a machine assembly to locate the shaft in both directions. The arrangement and preload must suit the load, required rigidity, temperature and fit tolerances.

Look beyond dimensions

When checking a designation, verify the bore diameter, outside diameter, total width, contact angle, dynamic/static load ratings, speed and the configuration of the cup-and-cone set. Two designations with similar dimensions but different contact angles or rated loads may have very different operating capabilities.

FAQ

Frequently asked questions

Why are single-row tapered roller bearings commonly mounted in pairs?

A single-row tapered roller bearing primarily carries axial load in one direction. Two bearings are normally arranged opposite each other when the shaft must be located in both directions. The arrangement also allows assembly rigidity to be adjusted through suitable clearance or preload.

Is more preload always better for tapered roller bearings?

No. Insufficient preload can leave the bearing arrangement with low rigidity or clearance, while excessive preload increases friction, heat and contact stress. The correct value must be determined from the load, speed, temperature and the machine or manufacturer's instructions.

Can a tapered roller bearing be replaced solely because d, D and width are identical?

No. Contact angle, load ratings, internal geometry, tolerances and the cup-and-cone configuration may differ. A replacement must be selected by comparing the complete designation and technical specifications, not only the envelope dimensions.

News about Bearings