UCFX

6 product code

UCFX

UCFX is a bearing housing or unit for shaft support. Select the mounting form and insert bearing according to the machine arrangement.

Loading product code list…

Detailed technical content

Choose the mounting style before selecting a designation

For a bearing unit, the method of mounting it to the machine must be identified in addition to the shaft diameter. A pillow-block style is suitable when the shaft runs parallel to the mounting surface; a flanged style is suitable for mounting on a wall or panel; and a take-up style is suitable where the bearing position must move for alignment or to maintain tension. Cartridge and hanger styles serve more specialized mounting arrangements.

Therefore, two units with the same bore diameter may not be interchangeable if their center height, bolt-hole spacing, housing style or mounting dimensions differ.

Shaft locking arrangements and operating conditions

The insert bearing in a unit may be secured to the shaft by several methods, including set screws, an eccentric locking collar, an adapter sleeve or a concentric locking collar, depending on the product series. Each arrangement has different installation characteristics and must be selected according to the equipment’s direction of rotation, load, speed, vibration and removal requirements.

Bearing units are normally pre-lubricated. Many cast-iron housing designs also support relubrication. In dusty or damp environments, washdown conditions or where contaminants are present, check the seal configuration, protective cover and grease type rather than considering only the basic designation.

Self-alignment has limits

The spherical outside surface of the insert bearing works with the matching spherical surface in the housing, allowing the unit to adjust for a degree of initial installation misalignment. This capability makes installation more flexible, but does not replace correct alignment of the shaft and machine base. Severe misalignment, housing deformation or incorrect bolt tightening can still reduce the unit’s service life.

When selecting the final designation, compare the shaft diameter, housing style, mounting dimensions, locking arrangement, seals, load, speed and operating environment together.

FAQ

Frequently asked questions

Can UCP, UCF, UCFL or UCT units be selected solely by shaft diameter?

No. Shaft diameter is only one required parameter. UCP, UCF, UCFL and UCT differ in mounting form, center height, bolt-hole number and position, housing dimensions and machine arrangement. Check the complete housing mounting dimensions and the available space on the equipment.

When should a take-up unit such as UCT be used instead of a plummer-block or flanged unit?

A take-up unit is suitable where the shaft support must move in one direction for alignment or tensioning, such as in certain drives, conveyors or tensioning mechanisms. A plummer-block or flanged unit is generally more suitable when the bearing position is fixed rigidly to a base or wall. Selection must follow the actual machine construction.

Can a bearing unit compensate for any amount of misalignment between shaft and housing?

No. The self-aligning construction accommodates only a small initial mounting misalignment. A severely misaligned shaft, uneven mounting base or housing distorted by excessive bolt tightening can still produce uneven internal loading. The machine must therefore be aligned correctly even when a self-aligning unit is used.

Is an eccentric locking collar suitable for a shaft that frequently reverses rotation?

Not always. FK notes that eccentric-collar units are not recommended where the direction of rotation changes frequently because the collar may loosen. For reversing operation, check a more suitable locking method and follow the instructions of the actual manufacturer.

News about Bearing housings