UK

3 product code

UK

UK is a bearing housing or unit for shaft support. Select the mounting form and insert bearing according to the machine arrangement.

Loading product code list…

Detailed technical content

Outside surface and operation in a housing

Insert bearings used in bearing units are generally based on deep-groove ball-bearing designs, but they have an extended inner ring and a spherical outside surface on the outer ring. When installed in a housing with a matching spherical surface, an insert bearing can accommodate a limited amount of initial misalignment between the shaft and the housing.

This capability depends on using the correct insert-bearing and housing combination; it does not mean that the insert bearing can be installed with arbitrary misalignment. If the insert bearing is replaced separately, check its outside dimensions, inner-ring width, lubrication-groove position and compatible housing designation.

Differences between shaft-locking methods

The catalog includes designs that use set screws in the inner ring, a tapered bore with an adapter sleeve and other locking methods. Set screws allow quick mounting on a cylindrical shaft; the tapered-bore and adapter-sleeve type clamps around the shaft according to a different principle and has its own tightening procedure.

Do not change from one locking method to another merely because the bore diameter is the same. Consider the speed, load, direction of rotation, vibration, concentricity requirements and ease of removal for the equipment.

Seals and lubrication

Insert bearings are normally pre-greased and pre-sealed. Manufacturers may offer several seal or shield types with different levels of protection and speed limits. When replacing a designation in a dusty, damp or high-temperature environment, or where hygiene is required, match the exact seal and lubricant configuration rather than comparing only the d × D × B dimensions.

FAQ

Frequently asked questions

Can insert bearings with the same bore diameter be directly interchanged?

Do not decide from shaft diameter alone. Inserts may differ in outside diameter, inner-ring width, locking method, lubrication position, seal design or load rating. When replacing only the insert in an existing housing, check the housing designation and the manufacturer's compatibility table.

When should adapter-sleeve locking be used instead of set screws?

An adapter-sleeve design is suitable where a tapered sleeve and nut are required to clamp around the shaft, while set screws permit quick direct mounting on a cylindrical shaft. Neither method is best for every application; consider load, speed, vibration, shaft tolerance and removal requirements.

Can an insert bearing be pressed or hammered directly onto the shaft?

Do not apply impact directly to sealing components or transmit mounting force through an unsuitable part. FK recommends using a press acting on the inner ring when the bore-to-shaft fit is tight instead of striking the bearing. Incorrect mounting can displace the slinger or damage the bearing before operation.

Does seal design matter when replacement inserts have exactly the same dimensions?

Yes. Seal design affects contamination protection, grease retention, friction and speed limits. Inserts with identical dimensions but different sealing systems may suit different environments. For contaminated, wet or high-speed positions, check the seal configuration of the exact designation.

News about Bearing housings