T

13 product code

T

T is a bearing housing or unit for shaft support. Select the mounting form and insert bearing according to the machine arrangement.

Loading product code list…

Selected code

T 204

Housing width - A31.8 mm
Overall height - H88.9 mm
Overall length - L96 mm

LDT will confirm price, stock and delivery time when the request is received.

Detailed technical content

The housing must match the bearing and mounting dimensions

A bearing housing cannot be selected independently by its external appearance alone. For replacement, check the compatible bearing type, bearing-seat dimensions, center height, bolt spacing, mounting style and shaft diameter of the complete assembly. For housings that use insert bearings, the seating surface inside the housing must match the outside diameter and surface form of the corresponding insert bearing.

P/PA, FB/FC/FL and T styles serve different mounting arrangements. A housing with similar overall dimensions may therefore still be unsuitable as a replacement if the shaft centerline or mounting-hole locations differ.

Split SNL housings and solid housings

Split housings such as SNL have a separate cap and base, making large bearings easier to install, inspect and maintain. Depending on the configuration, these housings can be used with self-aligning bearings such as self-aligning ball bearings, spherical roller bearings or CARB bearings, and offer multiple sealing, lubrication and shaft-arrangement options.

For small and medium-sized units using insert bearings, solid housings are generally simpler and faster to install. The choice between the two groups should be based on the bearing type, load, shaft size, maintenance requirements and machine construction, not only on price or appearance.

Rigidity, mounting surface and bolt tightening

The housing must be installed on a sufficiently flat and rigid surface to prevent twisting or deformation. Overtightening the bolts can deform the housing, while insufficient tightening can allow the assembly to move during operation. For heavy-duty applications or harsh environments, the housing material, sealing system and lubrication arrangement must also be checked against the manufacturer’s technical documentation.

FAQ

Frequently asked questions

Can any insert bearing be fitted into a housing of approximately the same size?

No. The insert and housing must be compatible in mounting-surface dimensions, outer-surface form, width and related lubrication or locking details. Products that appear similar may not fit correctly or may change the shaft center height. Check the manufacturer's insert-to-housing combination table or catalogue.

When should a split SNL housing be used instead of a solid housing?

An SNL housing is suitable where a removable cap is needed for convenient bearing installation and maintenance, especially for large shafts, large bearings or heavy-duty arrangements. Its split design also supports several bearing, seal and lubrication options. A solid housing is generally simpler and faster for small insert-bearing units.

When replacing a housing, must the center height and bolt-hole spacing remain unchanged?

Yes, if the machine's mounting geometry is to remain unchanged. A different center height can move the shaft away from its designed position, while different bolt-hole spacing or size can prevent direct installation on the existing base. Bearing compatibility and mounting-surface dimensions must also be checked.

Is tightening the housing bolts as much as possible always safer?

No. FK recommends the correct tightening torque because excessive tightening can distort the housing. The mounting surface should be flat, clean and sufficiently rigid, and the bolts should be tightened in the correct sequence and only enough to secure the housing without changing its geometry.

News about Bearing housings